Skip to content
Viscosity vpn connection issue
Got a problem with Viscosity or need help? Ask here!
- Posts: 1
- Joined: Sat Apr 20, 2019 5:43 am
Hi, I installed Viscosity for use my vpn connection in Mac OS X but when I try to connect I receive the following error (same vpn connection work in linux with OpenVPN client for linux):
2019-04-19 21:47:32: Viscosity Mac 1.7.14 (1480)
2019-04-19 21:47:32: Viscosity OpenVPN Engine Started
2019-04-19 21:47:32: Running on macOS 10.14.4
2019-04-19 21:47:32: ---------
2019-04-19 21:47:32: State changed to Connecting
2019-04-19 21:47:32: Checking reachability status of connection...
2019-04-19 21:47:32: Connection is reachable. Starting connection attempt.
2019-04-19 21:47:32: Options error: The command "XXXX" or one of its parameters is invalid for this version of OpenVPN (2.4.6). Please edit the connection, make sure the command is valid, and try again.
2019-04-19 21:47:32: Full command: test
2019-04-19 21:47:33: The OpenVPN subsystem could not be started.
2019-04-19 21:47:33: State changed to Disconnected
2019-04-19 21:47:32: Viscosity Mac 1.7.14 (1480)
2019-04-19 21:47:32: Viscosity OpenVPN Engine Started
2019-04-19 21:47:32: Running on macOS 10.14.4
2019-04-19 21:47:32: ---------
2019-04-19 21:47:32: State changed to Connecting
2019-04-19 21:47:32: Checking reachability status of connection...
2019-04-19 21:47:32: Connection is reachable. Starting connection attempt.
2019-04-19 21:47:32: Options error: The command "XXXX" or one of its parameters is invalid for this version of OpenVPN (2.4.6). Please edit the connection, make sure the command is valid, and try again.
2019-04-19 21:47:32: Full command: test
2019-04-19 21:47:33: The OpenVPN subsystem could not be started.
2019-04-19 21:47:33: State changed to Disconnected
Hi backherozzo,
The following lines in your log indicates that there is an invalid command in your connection:
https://www.sparklabs.com/support/kb/article/advanced-configuration-commands/#specifying-advanced-configuration-commands
Cheers,
James
The following lines in your log indicates that there is an invalid command in your connection:
Code: Select all
To resolve the error you can edit the advanced commands section for your connection and remove the invalid command listed in the log messages, and then try connecting again. For information on how to edit advanced commands please see:2019-04-19 21:47:32: Options error: The command "XXXX" or one of its parameters is invalid for this version of OpenVPN (2.4.6). Please edit the connection, make sure the command is valid, and try again.
2019-04-19 21:47:32: Full command: test
https://www.sparklabs.com/support/kb/article/advanced-configuration-commands/#specifying-advanced-configuration-commands
Cheers,
James
Web: https://www.sparklabs.com
Support: https://www.sparklabs.com/support
Twitter: https://twitter.com/sparklabs
Support: https://www.sparklabs.com/support
Twitter: https://twitter.com/sparklabs
2 posts
Page 1 of 1