Page 1 of 1

Disabling IPv6

Posted: Sun Apr 08, 2018 3:29 pm
by n8chavez
Is there a way to disable ipv6 in Windows using gateway routing?

Re: Disabling IPv6

Posted: Mon Apr 09, 2018 12:50 pm
by Eric
Hi n8chavez,

I'm not sure what you mean by this entirely. Viscosity has the option to block IPv6 traffic while connected under Preferences -> Advanced. If you're looking for something more advanced than this, you will need to script it - https://sparklabs.com/support/kb/articl ... connected/

Regards,
Eric

Re: Disabling IPv6

Posted: Mon Apr 09, 2018 4:52 pm
by n8chavez
Actually, I was referring to something like your post here

It seems to be for macos, but it's in the Windows section. I tried your instructions in the post but was unable to connect afterwards.

Re: Disabling IPv6

Posted: Mon Apr 09, 2018 5:22 pm
by Eric
Hi n8chavez,

Those routes are exactly what the previous option I referred to is adding. They should work on both macOS and Windows. If they're not, could you please post some extra information including your route table and information about your connection.

Regards,
Eric

Re: Disabling IPv6

Posted: Tue Apr 10, 2018 3:23 pm
by n8chavez
I assume you are referring to to the option below. Is that right? If so, that option only comes into effect if the VPN server does not support IPv6. Is there a way to disable fore the connection if the VPN server does support IPv6?

Image

Re: Disabling IPv6

Posted: Wed Apr 11, 2018 12:24 pm
by Eric
Hi n8chavez,

In that case, the instructions you linked from my previous post should work, please give them a go - viewtopic.php?t=1724#p4898

If you get stuck, please let me know where and I can assist.

Regards,
Eric