SparkLabs Forum.

Community Help.


How to use OpenVPN with Cisco AnyConnect?

My country is blocking most of the VPN protocols including (OpenVPN, PPTP and L2TP). So, I installed Cisco AnyConnect and OCServ on a private server and it is working. The question is how to run both? because once I'm connected to Cisco Anyconnect and everything working fine, and once Viscosity connects to the other server, everything stops working. Weird enough, I can ping some IPs and I get a reply, otherwise nothing is working.

I tried to exclude my OCServ IP from OpenVPN and changed its gateway to 127.0.0.1 but it is not working too.
Hi m_abdelfattah,

I would not advice connecting through another VPN connection, especially I would not recommend mixing VPN protocols like this either, this adds a lot of overhead and will effect your performance dramatically.

Obfsproxy might be an alternative for you, please see the following - http://sparklabs.com/support/kb/article ... viscosity/

Regards,
Eric
2 posts Page 1 of 1

Copyright © 2016 SparkLabs Pty Ltd. All Rights Reserved. Privacy Policy